The COLLAGEN GUMMY

• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

The second check is a knocking or banging sound, sometimes called water hammer, that happens specifically at the moment the fill valve shuts off rather than during the fill itself. This is far more often a mains pressure issue than a valve fault, caused by the sudden stop of a fast-moving column of water hitting the closed valve and sending a shock through the pipework. A fill valve replacement on its own will sometimes quieten this slightly, particularly if swapping to a bottom-entry valve which fills more gently, but it will not fully resolve a genuine water hammer problem, which usually needs an air-filled arrestor fitted at the supply if it persists.

Available space inside and around the cistern also narrows the choice. A shallow cistern with limited depth may not give a bottom-entry valve enough room to seat correctly, while a side-entry valve needs clear wall space at the right height with no other fittings in the way.

See the details at Plumb2U Epsom.

For more detail, see Plumb2U Epsom.

Get the wrong flush valve on a low-level system and the flush pipe will not seat properly, leading to leaks at the joint that only show up once the cistern has been refitted and the access panel closed up again. Get a close-coupled flush valve into a low-level tank and the outlet is simply too short to reach the flush pipe collar at all.

Two cisterns can sit on near-identical pans and still take completely different spare parts, and the reason comes down to how the cistern connects to the toilet below it. Close-coupled and low-level designs are the two most common configurations found on UK jobs, and confusing the two when ordering spares is one of the easier mistakes to make on a busy round.