The COLLAGEN GUMMY

• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

The flush plate itself is usually the first point of failure a customer notices, whether that is a button that has stopped actuating, a plate that has come loose from the wall, or a dual-flush mechanism that only performs a full flush regardless of which button is pressed. Because the plate connects to the cistern through a spindle or cable rather than sitting directly on top of it, the fault could sit at the plate, along the linkage, or at the flush valve itself, and each of those needs a different part.

A flush valve, by contrast, works as a straightforward seal at the base of the cistern that lifts to let water fall directly through into the pan under gravity, with no siphoning action involved, and shuts again once the float or timer mechanism allows it to reseat. Flush valves are what almost all dual-flush cisterns use, since a siphon's all-or-nothing action makes a genuine short flush difficult to achieve, whereas a valve can simply be held open for a shorter or longer period.

Fixing centres, meaning the distance between the two mounting holes in the pan, is the measurement that actually determines whether a seat will fit at all, and it varies enough between manufacturers that assuming a standard spacing is a common source of returned parts. The two most frequently seen spacings in the UK are around 140mm to 145mm and 160mm to 165mm centre to centre, and a seat bought for the wrong spacing simply will not sit over both holes.

A dual-flush button looks simple from the top of the cistern lid, but underneath it is doing a more complicated job than a single-flush handle ever had to. Pressing one half of the button needs to trigger a short flush, while the other half needs to lift the flush valve fully for a complete cycle, and the mechanism that makes this happen is usually either a rigid spindle or a flexible cable running down to the flush valve itself.

Locating the access plate is the first practical step, Plumb2U supplies and it is not always where it looks like it should be. Some concealed frames put the service access behind the flush plate itself, which simply hinges or unclips forward once the buttons are removed, while others use a separate panel elsewhere on the same wall or in an adjoining space such as an airing cupboard. Getting this wrong before checking the frame manufacturer's layout wastes time working into a wall that did not need opening.

A close-coupled cistern bolts directly onto the back of the pan with no visible pipework between the two. Because the outlet on the cistern base sits directly above the inlet on the pan, the flush valve or siphon needs a shorter outlet and often a rubber doughnut washer to seal the joint rather than a length of pipe. Fill valves on close-coupled units tend to be shorter in the body too, since there is less depth inside a compact tank.