The COLLAGEN GUMMY

• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

Before placing an order, it pays to note three things on site: whether the cistern sits flush to the pan or is wall-mounted above it, the fill valve's body length if there is a tight fit inside the tank, and whether the existing lever operates through the lid or via an external arm. Plumb2U carries fill valves, flush valves and levers suited to both close-coupled and low-level cisterns, stocked at trade prices for plumbers who need to get the right part on the first order rather than the second. Trade supplies despatch from Plumb2U's Epsom base to plumbers across the UK, and Plumb2U remains a straightforward call when the cistern type is not obvious from the pan alone.

Bottom-fix hinges are the traditional arrangement, with a bolt passing down through the pan from above and a nut and washer tightened from underneath the rim. This means access is needed both above and below the pan to fit or remove the seat, which is straightforward on a floor-standing toilet but considerably more awkward on a wall-hung pan where the underside is harder to reach, or where a previous fitting has corroded the nut solid against the porcelain.

Measuring before ordering saves a return trip: the thread diameter of the existing lever body, the distance from the lever mounting to the flush valve connection point, and whether the arm needs to sit above or below the water line all affect which replacement will actually fit. A lever bought to the wrong thread size will not seal against the cistern wall, however well the rest of the job goes.

Available space inside and around the cistern also narrows the choice. A shallow cistern with limited depth may not give a bottom-entry valve enough room to seat correctly, while a side-entry valve needs clear wall space at the right height with no other fittings in the way.

A side-entry fill valve takes its supply through the side wall of the cistern, typically a few centimetres up from the base, with the water pipe running horizontally into the tank. This is the older and still very common arrangement in UK homes, particularly where the supply pipe rises through a wall cavity or runs along a skirting board before turning up into the cistern. Side-entry valves are usually the easier option where floor space beneath the cistern is tight, since there is no need for the pipe to come straight up from below.

When a full lever replacement is needed, the fitting type has to match what is already there. Side levers, which mount through a hole in the side of the cistern, come in different thread diameters and in both metal and plastic bodies, and the arm length inside the tank needs to reach the flush valve or siphon without fouling the tank wall. Levers that mount through the lid, more common on close-coupled and concealed designs, connect via a spindle rather than a side arm and are not interchangeable with side-lever fittings.